WindO/I-NV4 User’s Manual 23-27
2 Security Function Configuration Procedure
23
User Accounts and the Security Function
8 Create the base screen to switch to and configure the security group.
On the Home tab, in the Screens group, click the arrow under New, and then click Base Screen.
The Screen Properties dialog box is displayed.
9 Specify the screen number of the base screen to switch to with Number on the General tab.
This is the same screen number as the screen number specified in step
6. 2 is specified here.
10
Click the Security tab.
11
Change Display to Permitted for the security group that will be permitted to display the base screen.
Set Display to Permitted for GroupA.
12
Configure the settings on each tab as necessary and click OK.
The Screen Properties dialog box closes.
This concludes configuring the project to protect the display of screens.
To Next Page
Loading...
General