IDEC WindO/I-NV4 User Manual

WindO/I-NV4 User’s Manual 31-25
2 USB Autorun Function
31
External Memory Devices
2 Press the command to execute.
The command executes.
3 When the command finishes executing, a screen appears indicating the execution result.
Press Ack to close the execution result screen and display the menu screen.
Production line A - replace
MICRO/I program
Copy MICRO/I program to USB
flash drive
Replace sound data Copy PLC program to USB
flash drive
Production line A - replace
PLC program
Run All Cancel
Confirmation
Press the command to execute.
• Pressing Run All causes all commands defined in the USB Autorun definition file (hgauto.ini) to execute
one by one.
• If security is enabled for the project on MICRO/I, a dialog appears for you to enter a user name and
password. For details, refer to “2.4 USB Autorun Function Security” on page 31-34.
• When uploading or downloading IDEC PLC program to a password-protected PLC, a dialog appears for
you to enter the password.
Do not remove the USB flash drive or SD memory card while command is executing.
Production line A - replace
MICRO/I program
Function
The following function completed
Ack
Result
If a command executes with a button (except the Run All), the menu screen is displayed after pressing Ack
on the execution result dialog.

IDEC WindO/I-NV4 Specifications

General

Brand	IDEC
Model	WindO/I-NV4
Category	Organizer
Language	English