IDEC WindO/I-NV4 - Page 1707

WindO/I-NV4 User’s Manual 35-93
6 Options
35
MICRO/I Specifications
● HG1P
Name Type No. Description HG4G HG3G
HG2G
-5F
HG2G
-5T
HG1G
Expansion
Module Clamp
HG9Z-XJ3PN05
For installing the expansion modules on
the back of the MICRO/I (Short).
5 pcs/pack
For total width 17.6 to 41.1 mm.
YES YES YES NO NO
HG9Z-XJ4PN05
For installing the expansion modules on
the back of the MICRO/I (Long).
5 pcs/pack
For total width 47.0 to 69.4 mm.
YES YES YES NO NO
HG9Z-XJ5PN05
For installing the expansion modules on
the back of the MICRO/I (Extra-Long).
5 pcs/pack
For total width 70.5 to 93.0 mm.
YES YES NO NO NO
L-shaped
Terminal Block
Connector for
I/O Module
HG9Z-PMT10LPN02
For MicroSmart I/O Module (10-pole)
2 pcs/pack
YES YES YES NO NO
HG9Z-PMT11LPN02
For MicroSmart I/O Module (11-pole)
2 pcs/pack
YES YES YES NO NO
Name Type No. Description
Maintenance Cable HG9Z-XCM42
USB cable to connect to a computer
Length: 2m
<Connector>
HG1P: USB Mini-B
Computer: USB Type-A
HG1P Optional Cable
HG9Z-XCP13
Communication Mode: RS422/485 or Ethernet
Length: 3m
<Connector>
HG1P: CA-19S1N128007S
Host: D-sub 25-pin Male Connector
HG9Z-XCP15
Communication Mode: RS422/485 or Ethernet
Length: 5m
<Connector>
HG1P: CA-19S1N128007S
Host: D-sub 25-pin Male Connector
HG9Z-XCP17
Communication Mode: RS422/485 or Ethernet
Length: 7m
<Connector>
HG1P: CA-19S1N128007S
Host: D-sub 25-pin Male Connector
HG1P Debug Cable HG9Z-PX12
Length: 2m
<Connector>
HG1P: CA-19S1N128007S
Host: Twisted Wire
Hand Strap HG9Z-PS4
Wrist strap
1 pc/pack
Wall-Mounted Hook HG9Z-PK3
Hook attached to the rear of the case
1 pc/pack
Includes two installation screws