IDEC WindO/I-NV4

To Next Page

To Previous Page

WindO/I-NV4 User’s Manual 4-3

1 Creating and Manipulating WindO/I-NV4 Project Data

Project Settings

3 Select Manufacturer and Communication Driver and then click OK.

■ Manufacturer

Select the manufacturer name of the external device used.

■ Communication Driver

Shows the communication driver list for the select manufacturer. Select the communication driver to use.

■ Expression of Device Address Format

Select the format for the device address.

This option can only be configured when Allen-Bradley is selected for Manufacturer.

This concludes creating project data.

Next you will create a screen. For details, refer to Chapter 5 “3.1 Properties of Base Screen Dialog Box” on page 5-14.

Allen-Bradley: Enter device addresses in the Allen-Bradley format.

Example: B 10:123/5

WindO/I-NV4: Enter device addresses in the WindO/I-NV4 format.

Example: B 1012305

You can return to the Select Communication Driver dialog box and change its setting by clicking

Previous.