Mitsubishi FR-A800

730
APPENDIX
 For details, refer to page 359.
 Run command
Users can specify the terminal function using this data. These bits function is depending on inverter parameter setting. (Refer to page 430)
<32bit data>
H003E Transistor thermal load factor 0.1% unsigned R
H003F reserved - - -
H0040 PTC thermistor resistance ohm unsigned R
H0041
Output power
(with regenerative display)
R
H0042 Cumulative regenerative power R
H0043 reserved
H0044 2nd PID set point 0.1% unsigned R/W
H0045 2nd PID measured value 0.1% unsigned R/W
H0046 2nd PID deviation 0.1% unsigned R/W
H0048 to
H004F
reserved - - -
H0050 Integrated power on time R
H0051 Running time R
H0052 Saving energy monitor R
H0053 reserved - - -
H0054 Fault code (1) - - R
H0055 Fault code (2) - - R
H0056 Fault code (3) - - R
H0057 Fault code (4) - - R
H0058 Fault code (5) - - R
H0059 Fault code (6) - - R
H005A Fault code (7) - - R
H005B Fault code (8) - - R
H00F9 Run command
 --R/W
H00FA to
H01FF
reserved - - -
b15 b0
----RES
STP
(STOP)
CS JOG MRS RT RH RM RL - - AU
No. Description Unit Type
Read/
write
H0200 reserved - - -
H0201 Output frequency (0-15bit)
0.01Hz signed R
H0202 Output frequency (16-31bit)
H0203 Setting frsequency (0-15bit)
0.01Hz signed R
H0204 Setting frequency (16-31bit)
H0205 Motor rotation (0-15bit)
1r/min signed R
H0206 Motor rotation (16-31bit)
H0207 Load meter (0-15bit)
0.1% signed R
H0208 Load meter (16-31bit)
H0209 Positioning pulse (0-15bit)
1signedR/W
H020A Positioning pulse (16-31bit)
H020B Watt-hour meter (1kWh step) (0-15bit)
1kWh unsigned R
H020C Watt-hour meter (1kWh step) (16-31bit)
H020D Watt-hour meter (0.1/0.01kWh step) (0-15bit)
0.1/0.01kWh unsigned R
H020E Watt-hour meter(0.1/0.01kWh step) (16-31bit)
H020F Position error (0-15bit)
1signedR
H0210 Position error (16-31bit)
H0211 to
H03FF
reserved - - -
No. Description Unit Type
Read/
write