Raisecom ISCOM2600G-HI (A) Series - Static route

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3 ISF
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
189
Raisecom(config-isf-port1/1/1)#exit
Raisecom(config)#interface isf-port 1/1/2
Raisecom(config-isf-port1/1/2)#isf port-group tengigabitethernet 1/1/27
Raisecom(config-isf-port1/1/2)#exit
2. Save running configurations to the startup configuration file.
Raisecom#write
3. Configure Switch A to ISF mode.
Raisecom#config
Raisecom(config)#isf mode isf
next unit is: 1, are you sure ? please input 'yes':yes
This config reboot go into effect, Please input 'yes' to reboot:yes
1970-01-01,08:07:17 System-4-SYSTEM_REBOOT:unit1: Change work Mode
reboot !
Operation successfully
BOOTROM starting ..
After Switch A is restarted, it forms an ISF that has only one member device.
Step 2 Configure Device B.
1. Configure the member ID of Switch B to 2 and member priority to 26.
Raisecom#config
Raisecom(config)#isf renumber 2
Raisecom(config)#isf priority 26
Raisecom(config)#interface tengigabitethernet 1/1/25
Raisecom(config-tengigabitethernet1/1/25)#exit
Raisecom(config)#interface tengigabitethernet 1/1/27
Raisecom(config-tengigabitethernet1/1/27)#exit
Raisecom(config)#interface isf-port 1/1/1
Raisecom(config-isf-port1/1/1)#isf port-group tengigabitethernet 1/1/25
Raisecom(config-isf-port1/1/1)#exit
Raisecom(config)#interface isf-port 1/1/2
Raisecom(config-isf-port1/1/2)#isf port-group tengigabitethernet 1/1/27
Raisecom(config-isf-port1/1/2)#exit
2. Save running configurations to the startup configuration file.
Raisecom#write