Raisecom ISCOM2600G-HI (A) Series - Page 221

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3 ISF
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
190
3. Configure Switch B to ISF mode.
Raisecom#config
Raisecom(config)#isf mode isf
next unit is: 9, please input 'yes':yes
This configuration will go into effect after reboot, Please input 'yes'
to reboot:yes
Will you change start-config ? please input 'yes' to change:yes
1970-01-01,08:06:46 System-4-SYSTEM_REBOOT:unit1: Change work Mode
reboot !
Operation successfully
Raisecom(config)#
BOOTROM starting ..
After Switch B is restarted, it joins the ISF with Switch A.
Step 3 Configure Switch C.
1. Configure the member ID of Switch C to 3 and member priority to 6.
Raisecom#config
Raisecom(config)#isf renumber 3
Raisecom(config)#isf priority 6
Raisecom(config)#interface tengigabitethernet 1/1/25
Raisecom(config-tengigabitethernet1/1/25)#exit
Raisecom(config)#interface tengigabitethernet 1/1/27
Raisecom(config-tengigabitethernet1/1/27)#exit
Raisecom(config)#interface isf-port 1/1/1
Raisecom(config-isf-port1/1/1)#isf port-group tengigabitethernet 1/1/25
Raisecom(config-isf-port1/1/1)#exit
Raisecom(config)#interface isf-port 1/1/2
Raisecom(config-isf-port1/1/2)#isf port-group tengigabitethernet 1/1/27
Raisecom(config-isf-port1/1/2)#exit
2. Save running configurations to the startup configuration file.
Raisecom#write
3. Configure Switch C to ISF mode.
Raisecom#config
Raisecom(config)#isf mode isf
next unit is: 3, are you sure ? please input 'yes':yes
This config reboot go into effect, Please input 'yes' to reboot:yes
1970-01-01,08:07:17 System-4-SYSTEM_REBOOT:unit1: Change work Mode
reboot !