Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Operation successfully
BOOTROM starting ..
After Switch C is restarted, it joins the ISF with Switch A and Switch B.
Step 4 Configure Switch D.
1. Configure the member ID of Switch D to 4 and member priority to 2.
Raisecom#config
Raisecom(config)#isf renumber 4
Raisecom(config)#isf priority 2
Raisecom(config)#interface tengigabitethernet 1/1/25
Raisecom(config-tengigabitethernet1/1/25)#exit
Raisecom(config)#interface tengigabitethernet 1/1/27
Raisecom(config-tengigabitethernet1/1/27)#exit
Raisecom(config)#interface isf-port 1/1/1
Raisecom(config-isf-port1/1/1)#isf port-group tengigabitethernet 1/1/25
Raisecom(config-isf-port1/1/1)#exit
Raisecom(config)#interface isf-port 1/1/2
Raisecom(config-isf-port1/1/2)#isf port-group tengigabitethernet 1/1/27
Raisecom(config-isf-port1/1/2)#exit
2. Save running configurations to the startup configuration file.
Raisecom#write
3. Configure Switch D to ISF mode.
Raisecom#config
Raisecom(config)#isf mode isf
next unit is: 4, are you sure ? please input 'yes':yes
This config reboot go into effect, Please input 'yes' to reboot:yes
1970-01-01,08:07:17 System-4-SYSTEM_REBOOT:unit1: Change work Mode
reboot !
BOOTROM starting ..
After Switch D is restarted, it joins the ISF with Switch A, Switch B, and Switch C.
To Next Page
Loading...
Need help?
General
