Raisecom ISCOM2600G-HI (A) Series - Page 365

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
8 Multicast
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
334
SwitchB(config-gigaethernet1/1/1)switchport mode trunk
SwitchB(config-gigaethernet1/1/1)#switchport trunk native vlan 200
SwitchB(config-gigaethernet1/1/1)#exit
SwitchB(config)#interface gigaethernet 1/1/2
SwitchB(config-gigaethernet1/1/2)#switchport mode trunk
SwitchB(config-gigaethernet1/1/2)#switchport trunk native vlan 200
Configure Switch C.
SwitchC#config
SwitchC(config)#spanning-tree enable
SwitchC(config)#spanning-tree mode stp
SwitchC(config)#interface gigaethernet 1/1/1
SwitchC(config-gigaethernet1/1/1)#switchport mode trunk
SwitchC(config-gigaethernet1/1/1)#switchport trunk native vlan 200
SwitchC(config-gigaethernet1/1/1)#exit
SwitchC(config)#interface gigaethernet 1/1/2
SwitchC(config-gigaethernet1/1/2)#switchport mode trunk
SwitchC(config-gigaethernet1/1/2)#switchport trunk native vlan 200
Step 2 Enable IGMP Snooping and IGMP ring network forwarding on the interface.
Configure Switch A.
SwitchA(config)#igmp ring gigaethernet 1/1/1
SwitchA(config)#igmp ring gigaethernet 1/1/2
SwitchA(config)#igmp snooping
SwitchA(config)#igmp snooping vlan 200
Configure Switch B.
SwitchB(config)#igmp ring gigaethernet 1/1/1
SwitchB(config)#igmp ring gigaethernet 1/1/2
SwitchB(config)#igmp snooping
SwitchB(config)#igmp snooping vlan 200
Configure Switch C.
SwitchC(config)#igmp ring gigaethernet 1/1/1
SwitchC(config)#igmp ring gigaethernet 1/1/2
SwitchC(config)#igmp snooping