Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Raisecom(config-gigaethernet1/1/3)#switchport mode trunk
Raisecom(config-gigaethernet1/1/3)#switchport trunk native vlan 3
Raisecom(config-gigaethernet1/1/3)#switchport trunk untagged vlan 12,13
Raisecom(config-gigaethernet1/1/3)#exit
Step 2 Configure IGMP MVR on Switch A.
Raisecom(config)#igmp mvr
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#igmp mvr
Raisecom(config-gigaethernet1/1/1)#igmp mvr user-vlan 13
Raisecom(config-gigaethernet1/1/1)#exit
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#igmp mvr
Raisecom(config-gigaethernet1/1/2)#igmp mvr user-vlan 12
Raisecom(config-gigaethernet1/1/2)#exit
Raisecom(config)#igmp mvr mcast-vlan 3 group 234.5.6.7
Raisecom(config)#igmp mvr mcast-vlan 3 group 225.1.1.1
Checking results
Use the following command to show IGMP MVR configurations on Switch A.
Raisecom#show igmp mvr
igmp mvr running :Enable
igmp mvr port :GE1/1/1 GE1/1/2
igmp mvr multicast vlan(ref) :3(2)
igmp aging time(s) :260
igmp ring :--
Use the following command to show information about the multicast VLAN and group
address.
Raisecom#show igmp mvr vlan-group
-----------------------------------------------------
Raisecom(config)#show igmp mvr vlan-group
Mcast-vlan Start-group End-group
-------------------------------------------
3 225.1.1.1 225.1.1.1
3 234.5.6.7 234.5.6.7
To Next Page
Loading...
Need help?
General
