Raisecom ISCOM2600G-HI (A) Series - Page 447

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
416
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#ip arp-rate-limit rate 20
Raisecom(config-gigaethernet1/1/2)#exit
Checking results
Use the show ip arp-inspection command to show configurations of interface trust status and
static/dynamic ARP binding.
Raisecom#show ip arp-inspection
Static Config ARP Inspection: Enable
Static Config ARP Inspection: Enable
DHCP Snooping ARP Inspection: Disable
ARP Inspection Protect Vlan : 1-4094
Bind Rule Num : 1
Vlan Rule Num : 0
Bind Acl Num : 1
Vlan Acl Num : 0
Remained Acl Num : 511
Port Trust
----------------------------------------
gigaethernet1/1/1 no
gigaethernet1/1/2 no
gigaethernet1/1/3 yes
gigaethernet1/1/4 no
gigaethernet1/1/5 no
gigaethernet1/1/6 no
gigaethernet1/1/7 no
……
Use the show ip arp-inspection binding command to show information about the dynamic
ARP binding table.
Raisecom#show ip arp-inspection binding
Ip Address Mac Address VLAN Port Type
Inhw
-------------------------------------------------------------------------
----------------------
10.10.10.1 -- -- gigaethernet1/1/1 static
yes
Current Rules Num : 1
History Max Rules Num : 1
Use the show ip arp-rate-limit command to show configurations of rate limiting on the
interface and auto-recovery time for rate limiting.