Raisecom ISCOM2600G-HI (A) Series - System log

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
11 Reliability
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
481
Switch2(config-iccp)#member-ip 10.110.3.1
Switch2(config-iccp)#iccp enable
Switch2(config-iccp)#exit
Switch2(config)#mlacp-group 1
Switch2(config-ic-group)#iccp-channel 1
Switch2(config-ic-group)#port-channel 1
Switch2(config-ic-group)#mlacp slave
Switch2(config-ic-group)#restore-mode revertive restore-delay 20
Switch2(config-ic-group)#exit
Checking results
Use the following command to show LACP configurations of the DHD.
DHD#show port-channel 1
Group 1 information:
Mode : Lacp Load-sharing mode : src-dst-mac
MinLinks: 2 Max-links : 2
UpLinks : 4 Priority-Preemptive: Enable
Member Port : gigaethernet1/1/1 gigaethernet1/1/2 gigaethernet1/1/4
gigaethernet1/1/3
Efficient Port: gigaethernet1/1/1 gigaethernet1/1/2
Use the following command to show mLACP configurations of Switch 1.
Switch1#show mlacp-group 1
mlacp group : 1
System information:
MAC address running : 000E.5E11.2233
System priority running : 20000
Configuration information:
Local information Peer information
system mac: 000E.5E55.0001 000E.5E11.2233
System priority: 20000 32768
Port-channel: 1 N/A
Type: master slave
Iccp-channel: 1 N/A
Iccp-State: connect N/A
Track PwId: 0 N/A
Pw Ip: 0.0.0.0 N/A
Pw state: N/A N/A
State: Active Standby
Restore Type: revertive N/A
Restore Time(s): 20 N/A
Use the following command to show mLACP configurations of Switch 2.