Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Configure a LAG for Switch 2. Add GE 1/1/1 and GE 1/1/2 on Switch 2 to the LAG and
enable priority pre-emption of the LAG.
Switch2#config
Switch2(config)#interface port-channel 1
Switch2(config-port-channel1)#mode lacp
Switch2(config-port-channel1)#max-active links 2
Switch2(config-port-channel1)#min-active links 2
Switch2(config-port-channel1)#lacp priority preempt enable
Switch2(config-port-channel1)#interface gigaethernet 1/1/1
Switch2(config-gigaethernet1/1/1)#port-channel 1
Switch2(config-gigaethernet1/1/1)#interface gigaethernet 1/1/2
Switch2(config-gigaethernet1/1/2)#port-channel 1
Step 2 Configure an ICCP channel and bind it with the ICG. Apply the ICCP channel to the LAG.
Configure Switch 1 as below:
Switch1#config
Switch1(config)#create vlan 6 active
Switch1(config)#interface gigaethernet 1/1/3
Switch1(config-gigaethernet1/1/3)#switchport access vlan 6
Switch1(config-gigaethernet1/1/3)#interface vlan 6
Switch1(config-vlan6)#ip address 10.110.3.1 255.255.255.0
Switch1(config-vlan6)#exit
Switch1(config)#iccp local-ip 10.110.3.1
Switch1(config)#iccp channel 1
Switch1(config-iccp)#member-ip 10.110.3.2
Switch1(config-iccp)#iccp enable
Switch1(config-iccp)#exit
Switch1(config)#mlacp-group 1
Switch1(config-ic-group)#iccp-channel 1
Switch1(config-ic-group)#mlacp master
Switch1(config-ic-group)#mlacp system-priority 20000
Switch1(config-ic-group)#port-channel 1
Switch1(config-ic-group)#restore-mode revertive restore-delay 20
Switch1(config-ic-group)#exit
Configure Switch 2 as below:
Switch2#config
Switch2(config)#create vlan 6 active
Switch2(config)#interface gigaethernet 1/1/3
Switch2(config-gigaethernet1/1/3)#switchport access vlan 6
Switch2(config-gigaethernet1/1/3)#interface vlan 6
Switch2(config-vlan6)#ip address 10.110.3.2 255.255.255.0
Switch2(config-vlan6)#exit
Switch2(config)#iccp local-ip 10.110.3.2
Switch2(config)#iccp channel 1
To Next Page
Loading...
