Raisecom ISCOM2600G-HI (A) Series - Page 539

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
508
Configure Switch B.
SwitchB(config)#create vlan 1024 active
SwitchB(config)#interface gigaethernet 1/1/1
SwitchB(config-gigaethernet1/1/1)#switchport access vlan 1024
SwitchB(config)#interface vlan 1024
SwitchB(config-vlan1)#ip address 10.10.10.2 255.255.255.0
SwitchB(config-vlan1)#exit
Step 3 Configure LLDP attributes.
Configure Switch A.
SwitchA(config)#lldp message-transmission interval 60
SwitchA(config)#lldp message-transmission delay 9
SwitchA(config)#lldp trap-interval 10
Configure Switch B.
SwitchB(config)#lldp message-transmission interval 60
SwitchB(config)#lldp message-transmission delay 9
SwitchB(config)#lldp trap-interval 10
Checking results
Use the show lldp local config command to show local configurations.
SwitchA#show lldp local config
System configuration:
------------------------------------------------------------------
LLDP enable status: enable (default is disabled)
LldpMsgTxInterval: 60 (default is 30s)
LldpMsgTxHoldMultiplier: 4 (default is 4)
LldpReinitDelay: 2 (default is 2s)
LldpTxDelay: 9 (default is 2s)
LldpNotificationInterval: 10 (default is 5s)
LldpNotificationEnable: enable (default is enabled)
------------------------------------------------------------------
Port Status Packet destination-mac
--------------------------------------------------------
GE1/1/1 enable 0180.C200.010e
GE1/1/2 enable 0180.C200.010e
GE1/1/3 enable 0180.C200.010e
GE1/1/4 enable 0180.C200.010e
GE1/1/5 enable 0180.C200.010e
GE1/1/6 enable 0180.C200.010e