Raisecom ISCOM2600G-HI (A) Series - Page 98

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
67
Checking results
Use the show vlan command to show VLAN configurations.
Take Switch B for example.
SwitchB#show vlan
Switch Mode: --
VLAN Name State Status Priority Member-Ports
------------------------------------------------------------------------
1 Default active static -- P 1-6
2 VLAN0002 active other -- P 1-28
10 VLAN0010 active static -- gigaethernet1/1/2
gigaethernet1/1/3
20 VLAN0020 active static -- gigaethernet1/1/4
Use the show switchport interface interface-type interface-number command to show
configurations of the interface VLAN.
Take Switch B for example.
SwitchB#show switchport interface gigaethernet 1/1/2
Interface: gigaethernet1/1/2
Switch Mode: switch
Reject frame type: none
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 10
Administrative Access Egress VLANs:
Operational Access Egress VLANs: 10
Trunk Native Mode VLAN: 1
Trunk Native VLAN: untagged
Administrative Trunk Allowed VLANs:
Operational Trunk Allowed VLANs: 1
Administrative Trunk Untagged VLANs:
Operational Trunk Untagged VLANs: 1
Administrative private-vlan host-association: 1
Administrative private-vlan mapping: 1
Operational private-vlan: --
Check whether the Trunk interface permitting VLAN passing is correct by making PC 1 ping
PC 5, PC 2 ping PC 5, and PC 3 ping PC 4.

PC 1 can ping through PC 5, so VLAN 10 communication is normal.

PC 2 can ping through PC 5, so VLAN 10 communication is normal.

PC 3 fails to ping through PC 4, so VLAN 20 communication is abnormal.