18 Operations Water Management functionality
Clip a portion of a section line
You can remove a portion of the section line from either the beginning or end of the line (or both).
1. At the Design tab, tap Design to open the Design screen.
2. Go to the Edit Line tab.
3. From the far left-hand list at the bottom of the screen, choose either Clip Start or Clip End
(depending on which end of the line you want to remove).
4. Indicate where you want to clip to by:
a. Touching on the screen
b. Moving the slider
c. Entering a specific distance in the Distance entry box
5. When you have finished indicating the areas to clip, tap Delete All.
6. To save the changes, tap OK.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 463
To Next Page
Loading...