Water Management functionality 18 Operations
Add a fixed point
You can add a fixed point to your design. This enables you to avoid:
l An underground structure
l Intersecting a specific depth or existing tile line
1. At the Design tab, tap Design to open the Design screen.
2. Go to the Edit Line tab.
3. From the far left-hand list at the bottom of the screen, choose Fix Point.
4. Indicate where you want the fixed point by:
a. Touching on the screen
b. Moving the slider
c. Entering a specific distance in the Distance entry box
5. Tap Add. The screen will show the design elevation for the fixed point.
6. Enter the elevation that represents the target or obstacle. The system redesigns the section line
to account for the new fixed point. If the slope approaching the point is now too steep, you
have the option to enter more fixed points ahead of the original fixed point to make the
transition better from one slope to the next.
Define boot depth
You can define the boot depth by either of the steps below.
l Option 1:Enter the relative depth above and below the surveyed surface.
l Option 2: Enter a specific elevation in the Outlet Elevation entry box. The system calculates the
other box.
464 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...