19 Diagnostics Field-IQ diagnostics
Message That Displays Explanation Possible Causes / Actions
calibration for anhydrous,
the vehicle must be moving
at a speed of at least 2
mph. If the vehicle speed is
above 2 mph, check that
the FM-1000 integrated
display is receiving valid
GPS positions.
Valve Calibration Failed The vehicle is moving too
slow to continue the
automatic valve calibration.
Increase the speed of the vehicle and
start the valve calibration again.
Please turn off the master
switch
The Field-IQ system is in a
mode in which material
application is not expected.
It is asking for the master
switch to be turned off to
make the system safe.
NH3 is an irritant and
corrosive to the skin, eyes,
respiratory tract and
mucous membranes and is
dangerous if not handled
properly. May cause severe
burns to the eyes, lungs
and skin. Skin and
respiratory related diseases
could be aggravated by
exposure. It is
recommended that
protective gloves, boots,
slicker and/or pants and
jacket, and chemical-splash
goggles that are impervious
to anhydrous ammonia are
worn at all times.
The application type is set
to Anhydrous
Application width is
different from the control
width.
Please visit Field-IQ setup
The total of the rate
controller widths in the
Hardware tab of the Field-
Version 9.25, Revision B FM-1000 Integrated Display User Guide 489
To Next Page
Loading...