Field-IQ diagnostics 19 Diagnostics
Message That Displays Explanation Possible Causes / Actions
to reconfigure settings.
IQ Setup must match the
application width in the
Implement Setup. A
difference of about 0.4
inches is tolerated.
Application width is
different from the control
and section width.
Do you want the control
and section width to be
automatically adjusted to
match the application
width?
This message could appear
when you exit the Field-IQ
Setup.
The total of the rate
controller widths in the
Hardware tab of the Field-
IQ Setup must match the
application width in the
Implement Setup. A
difference of about 0.4
inches is tolerated.
Please select your NH3 unit This messages shows if the
application type is
anhydrous and you
attempt to exit the Field-IQ
Setup without selecting the
Anhydrous Units type ("lbs.
Actual N" or "lbs. NH3") in
the Features tab.
The total number of rows
assigned to sections (XX)
exceeds the number of
rows on the implement
(XX)
Press Continue to exit the
Field-IQ Setup or press Edit
to edit the row
assignments.
This message may appear
when you exit the Field-IQ
Setup.
The total of the numbers in
the fields in the Sections
tab exceeds the number of
rows configured in the
Implement Setup.
XX implement rows are not
assigned to sections
Press Continue to exit the
Field-IQ Setup or press Edit
to edit the row
assignments.
This message may appear
when you exit the Field-IQ
Setup.
The total of the numbers in
the fields in the Sections
tab exceeds the number of
rows configured in the
Implement Setup.
490 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...