19 Diagnostics Field-IQ diagnostics
Message That Displays Explanation Possible Causes / Actions
The number of nozzles
must not be less than the
total number of sections.
This message could appear
when you exit the Field-IQ
Setup.
The total number of
sections in the Hardware
tab exceeds the Total
Nozzles setting in the Rate
tab. There must be at least
as many nozzles as
sections.
Some devices have not
been identified by serial
number.
This message shows when
you exit the Field-IQ Setup,
if one or more of the serial
number selection fields in
the Hardware tab has no
serial number selected.
None of the expected Field-
IQ system devices were
found on the implement.
Do you want to switch to
another implement
configuration?
The rate and/or section
controllers that are
identified in the current
Field-IQ system
configuration were not
detected on the CAN bus.
None of the configured
Field IQ devices are
connected.
Do you want to remove all
of the missing devices from
the Field IQ hardware
configuration?
The rate and/or section
controllers that are
identified in the current
Field\ IQ configuration
were not detected on the
CAN bus.
Fence nozzle is enabled The
configured sections exceed
the maximum that is
supported
Please reduce the number
of sections
If the left fence nozzle is
enabled in the Sections tab
of the Field IQ Setup, the
leftmost section controller
must not have more than
11 sections.
If the right fence nozzle is
enabled in the Sections tab
of the Field-IQ Setup, the
rightmost section
controller must not have
more than 11 sections.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 491
To Next Page
Loading...