Field-IQ diagnostics 19 Diagnostics
Message That Displays Explanation Possible Causes / Actions
Cannot flush because the
system is not calibrated.
This message appears if
you try to use the Manual
Flush button in the
Tank/Bin tab of the Field-IQ
Setup when a rate
controller is not yet
calibrated.
Rate and Section Control
Module and Rawson
Control Module can not be
present at the same time.
Please disconnect either
device before continuing
setup.
When using multiple rate
controllers for 1 material,
they must all be of the
same type.
Field-IQ has been disabled
Rate and Section Control
Module and Rawson
Control Module cannot be
present at the same time.
When using multiple rate
controllers for 1 material,
they must all be of the
same type.
Field-IQ has been disabled
One or more of the Field-IQ
system devices requires
calibration
Go to the calibration screen to
calibrate a controller.
Please enter a valid
flowmeter calibration
constant
The flow meter constant
must be greater than zero.
Weighed NH3 (End) must
be less than Weighed NH3
(Start).
This appears during
anhydrous flow calibration.
The process requires you to
enter the weighed amounts
of NH3 at the start and end
of a run. If this warning
appears, it is likely that you
transposed the two
amounts.
No target rate
The flush cannot be
performed until a target
This will appear if you try to
flush when the current
target rate is zero.
492 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...