501-16-5 Wipers and Washers 501-16-5
DIAGNOSIS AND TESTING
Pinpoint Tests
PINPOINT TEST A: THE WIPERS ARE INOPERATIVE
CONDITIONS
DETAILS/RESULTS/ACTIONS
A1: DETERMINE THE FAULT CONDITION
1.
2 Turn the multifunction switch to the SLOW
WIPER SPEED position.
• Is the slow wiper speed inoperative?
Yes
GO TO A2
No
GO TO A8
A2: DETERMINE THE FAULT CONDITION
1 Turn the multifunction switch to the FAST
WIPER SPEED position.
• Is the fast wiper speed inoperative?
Yes
GO TO A3
No
GO TO A10
A3: CHECK THE FUSE F12
1.
2.
Fuse F12 (CJB)
3 Check the fuse F12 (20 A).
• Is the fuse OK?
Yes
GO TO A4
No
INSTALL a new fuse F12. If the fuse blows
again, LOCATE and REPAIR the short cir-
cuit by using the wiring diagrams. TEST the
system for normal operation.
E9432 EN 07/2001 2002 Bantam
To Next Page
Loading...
