WindO/I-NV4 User’s Manual 3-11
5 User Communication
3
Communication
6 Enter the name of the user communication protocol that will be set in Protocol Name.
The maximum number for protocol name is 40 characters.
7 Set the time out (0 to 255) in Receiving Character Time Out (x100 msec).
For details on the Receiving Character Time Out (x100 msec), refer to “Receiving Character Time Out (x100
msec)” on page 3-32.
You cannot use the following characters in the protocol name.
" * , / : ; < > ? \ |
To Next Page
Loading...