2 USB Autorun Function
31-28 WindO/I-NV4 User’s Manual
command = PRO_DOWNLOAD
■ src_path (required)
Specify the path (250 or less characters) where the project file is to be downloaded.
■ reset_keep_device
Specify whether to initialize the keep devices or not when the project file is downloaded. However, when project data
that changes the settings of the data storage area is downloaded, the keep devices are always initialized.
command = PRO_UPLOAD
■ dst_path (required)
Specify the path to the folder (250 or less characters) where the uploaded project will be saved.
command = LDR_DOWNLOAD
■ src_path (required)
Specify the path (250 or less characters) where the ZLD Project File is to be downloaded.
■ dst_port (required)
Specify the name of the MICRO/I port to which the PLC to download from is connected. For details about the port
name, refer to Chapter 4 “Interface Configuration” on page 4-35.
*1 Only special product of HG1P is equipped with a serial interface (RS232C).
HG2J-7U: Use "A:\" for a USB flash drive inserted in USB1 and "B:\" for a USB
flash drive inserted in USB2.
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F: Use "A:\" for an SD memory card and "B:\" for a USB flash drive.
HG2G-5T, HG1G/1P: Use "B:\" for a USB flash drive.
Enable: Initializes the keep devices.
Disable: Does not initialize the keep devices.
If you download the project data, Alarm Log data, Operation Log data, and Data Log data is erased
regardless of the reset_keep_device.
If this item is left blank or contains an illegal value, the MICRO/I assumes "Enable".
HG2J-7U: Use "A:\" for a USB flash drive inserted in USB1 and "B:\" for a USB
flash drive inserted in USB2.
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F: Use "A:\" for an SD memory card and "B:\" for a USB flash drive.
HG2G-5T, HG1G/1P: Use "B:\" for a USB flash drive.
HG2J-7U: Use "A:\" for a USB flash drive inserted in USB1 and "B:\" for a USB
flash drive inserted in USB2.
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F: Use "A:\" for an SD memory card and "B:\" for a USB flash drive.
HG2G-5T, HG1G/1P: Use "B:\" for a USB flash drive.
COM1: The name of the serial interface varies based on the model.
HG2J-7U, HG1G/1P
*1
:
COM(RS232C)
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F: COM1
HG2G-5T: SERIAL1(RS232C)
COM2: The name of the serial interface varies based on the model.
HG2J-7U, HG1G/1P: COM(RS422/485)
HG5G/4G/3G/2G-V: COM2(RS232C) or COM2(RS422/485)
HG4G/3G, HG2G-5F: COM2
HG2G-5T: SERIAL1(RS422/485)
ETHER: Ethernet interface (LAN)
To Next Page
Loading...
General