IDEC WindO/I-NV4 User Manual

WindO/I-NV4 User’s Manual 36-5
2 Handling Problems
36
Troubleshooting
2.1 When You Cannot Download Project Data
■ HG2J-7U
Turn on the power while pressing the RESET switch on the back with a fine-tipped object, and keep pressing it for at
least three seconds. However, do not use anything with a fragile or sharp tip.
When the POWER LED turns orange and changes from blinking to lit, a message is displayed and MICRO/I becomes
downloadable status. The IP address of the HG2J-7U type is 192.168.1.150. Please check the communication
settings, and then download.
■ HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P
Press the top left corner of the panel for three seconds or longer while at the same time turning the power off and
back on again.
The screen in the System Mode is displayed, and then MICRO/I becomes downloadable status. If you download via
Ethernet, check again the setting of TCP/IP before executing the download.
When MICRO/I does not show the System Mode screen and continues a blackout having a bleep each second, be sure
to download a project using a port for USB.
2.2 If the backlight is OFF and the buzzer sounds
If you fail to download the runtime program to MICRO/I, the backlight may turn to OFF and a beep may sound
continuously every second, even after the power has been turned off and on again. Rectify the situation by
downloading the project using WindO/I-NV4 via USB cable.
2.3 Touch Panel Does Not Respond Correctly
■ HG2J-7U
Press the RESET switch on the back with a fine-tipped object or turn the power off and then on again.
■ HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P
If the touch panel needs to be readjusted, then go to the System Mode to readjust the touch panel. For details about
adjusting method, refer to Chapter 34 “Touch Panel Adjust (TP Adjust)” on page 34-9.
2 Handling Problems
HG3G HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P HG2J-7U
Back
RESET switch
Fine-tipped object
MICRO/I
HG3G HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P HG2J-7U
When the backlight is OFF and the buzzer sounds, you cannot download the project to MICRO/I via Ethernet
or using an external memory.
HG3G HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P HG2J-7U

IDEC WindO/I-NV4 Specifications

General

Brand	IDEC
Model	WindO/I-NV4
Category	Organizer
Language	English