WindO/I-NV4 User’s Manual 4-21
1 Creating and Manipulating WindO/I-NV4 Project Data
4
Project Settings
● Changing Communication Drivers
This section describes how to change the communication driver set in the project data being edited.
1 With Communication Driver on the status bar, click one of External Device Communication 1 to External
Device Communication 4.
The Communication Driver tab on the Project Settings dialog box is displayed.
2 Change the settings on each tab as necessary.
3 Click the Communication Driver Network tab, change the settings as necessary and then click OK.
The confirmation message is displayed.
To Next Page
Loading...