10 Numerical Display
10-194 WindO/I-NV4 User’s Manual
â– Flash
*3
Select this check box to make the text and plate colors flash.
The flashing will occur as follows:
• The Change Display Colors check box is cleared, then the colors specified by Text Color and Plate Color on
the View tab and the colors specified by Text Color and Plate Color under Flash are alternately displayed.
• The Change Display Colors check box is selected and the value of the trigger device address for Change
Display Colors is 0, then the colors specified by Text Color and Plate Color on the View tab and the colors
specified by Text Color and Plate Color under Flash are alternately displayed.
• The Change Display Colors check box is selected and the value of the trigger device address for Change
Display Colors is 1, then the colors specified by Text Color and Plate Color under Change Display Colors
and the colors specified by Text Color and Plate Color under Flash are alternately displayed.
*3 Advanced mode only
1234
1234
1234
1234
Flashing
Trigger device address
under Flash
Trigger device address
under Flash
0
1
MICRO/I
External device
Text Color
Plate Color on the View tab
Text Color
Plate Color on
the View tab
Text Color under Flash
Plate Color under Flash
1234
1234
1234
1234
Flashing
Trigger device address
under Flash
Trigger device address
under Flash
MICRO/I
External device
Text Color
Plate Color on the View tab
Text Color
Plate Color on
the View tab
Text Color under Flash
Plate Color under Flash
Trigger device address under
Change Display Colors
Trigger device address under
Change Display Colors
0
0
1
0
1234
1234
1234
1234
Flashing
1
Trigger device address under
Change Display Colors
Trigger device address
under Flash
Trigger device address under
Change Display Colors
Trigger device address
under Flash
0
1
1
MICRO/I
External device
Text Color under
Change Display Colors
Plate Color under
Change Display Colors
Text Color under Change Display Colors
Plate Color under Change Display Colors
Text Color under Flash
Plate Color under Flash