IMC CANSAS - Extras - Options

104 Operation
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
3.4.5.2 Extras - Options
3.4.5.2.1 Module
Purpose: Settings options affecting the software's general behavior.
Readable configuration: It is possible to read a configuration into a module in such a way that it can later
be read by the software. This makes it possible for a module's configuration to be taken up in the
database although it was made on a different PC. See the description for "Readable configuration" below.
Measurement data of bridge - strain gauge: Give positive values for strain. Valid after reset or new
integration of a module. -> Information to strain gauges .
Calibration: Show state of calibration. For further information see here .
Firmware-Update: Enforce firmware in case of incompatibility between PC software and firmware of the
module. Since imc CANSAS version 1.6 the handling of the firmware has been changed. This could cause
incompatibilties with older versions.
182
227