IMC CANSAS - Edit; Edit - Undo; Edit - Cut; Edit - Copy

Menu functions 85
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
3.4.2 Edit
3.4.2.1 Edit - Undo
Purpose: Reverses the effect of the last command carried out.
Shortcuts
Keyboard: CTRL+Z
Remarks: You can use this item to undo the last editing action performed, wherever this is still possible.
The command only works on the controls of the Properties dialogs and when editing names in the
Module Tree.
3.4.2.2 Edit - Cut
Purpose: Deletes data from an input box and transfers them to the Clipboard.
Shortcuts
Toolbar:
Keyboard: CTRL+X
Remarks: Use this command to remove the currently selected data from the input box to the Clipboard.
The command can't be used if there is no current selection. The command only works on the controls of
the Properties dialogs and when editing names in the Module Tree.
Data removed to the Clipboard by this command replace any data which previously were held in the
Clipboard.
3.4.2.3 Edit - copy
Purpose: Copies data from a dialog box or module settings to the Clipboard
Shortcuts
Toolbar:
Keyboard: CTRL+C
Remarks: Use this command to copy the currently selected data to the Clipboard. The command can't be
used if there is no current selection. The command only works on the controls of the Properties dialogs
and when editing names in the Module Tree.
Data copied to the Clipboard by this command replace any data which previously were held in the
Clipboard.
There is another possibility if the entry for a imc CANSAS module is selected in the Module Tree. In this
case, all the settings for the entire module are copied to the Clipboard. Using the command Edit-Paste,
the settings can then be transferred to another module of the same type