IMC CANSAS - Synchronization

456 Properties of the Modules
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
6.27.1 Synchronization
Synchronization of the imc µ-CANSAS-HUB4 modules is performed exclusively as Slave according to the
CAN1-protocol.
Within the HUBs, the imc µ-CANSAS modules connected are synchronized. If the imc µ-CANSAS-HUB4 is
synchronized to CAN1-Slave, then the connected imc µ-CANSAS modules are also synchronized to the
other synchronized CAN-Bus participants.
Note
For synchronization to be indicated by a blinking code, the LEDs must be configured accordingly.
See the section imc CANSAS blinking codes .
220