IMC CANSAS - Features and Modules

CANSAS blinking codes 225
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
5.6 Features and modules
Many features available with the imc CANSAS software version 1.4 are dependent on the hardware
properties of particular imc CANSAS modules. This means a particular hardware version, i.e. a specific
circuit board, is required in order to access the software features. The list below indicates which features
are associated with which production dates. If you detect any discrepancies, please contact our hotline
for an exact clarification of your hardware version.
Below is a table of general features available as of the production date stated. Explanations of the
features appear further below.
Module
Slot
Synchronization
Readable configuration
imc-Sensors
C12
--
--
--
--
ISO8
--
--
--
--
BRIDGE2
--
--
--
--
DI16
from 06-2009
--
from 2006
--
L-DI16
from 07-2003
--
all
--
IGN
--
--
all
--
INC4
from 09-2003
from 2006
from 2006
--
L-INC4
from 07-2003
from 09-2003
all
--
DO16
from 12-2003
--
from 12-2003
--
DO8R
from 12-2003
--
from 12-2003
--
DO16R
from 07-2003
--
all
DAC8
from 09-2003
--
from 2006
--
L-DAC8
from 07-2003
--
all
--
PWM8
all
--
all
--
C8
all
all
all
--
UNI8
from 07-2003
from 06-2003
all
all
P8
from 07-2003
from 08-2003
all
--
SCI8
all
all
all
from 02-2007
SCI16
all
all
all
from 02-2007
SC16
all
all
all
from 02-2007
CI8
all
all
all
all
DAC8: special feature from production date
Module
Outputs each set for I/U separately
DAC8
from 09-2003