IMC CANSAS - Uni8 - Teds

222 Measurement Technique
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
Top-level code
Description
Subordinate code
Error description
RED --- YELLOW
ERROR WRITING
RED --- GREEN
DELETE ERROR BLOCK
YELLOW --- RED
DELETE ERROR CHIP
YELLOW --- YELLOW
FLASH PAGE TOO SMALL
GREEN --- RED
CanBus-access
RED --- RED
LINE TROUBLE
RED --- YELLOW
PACKET LOST
GREEN --- YELLOW
Fifo
RED --- RED
FIFO FULL
RED --- YELLOW
FIFO EMPTY
GREEN --- GREEN
General internal error
RED --- RED
ILLEGAL CALL
RED --- YELLOW
ILLEGAL DATA
RED --- GREEN
ILLEGAL LENGTH (structure)
YELLOW --- RED
RAM TEST
YELLOW --- YELLOW
NO ONLINE
YELLOW --- GREEN
INITIALIZATION FPGA
For the imc CANSAS modules UNI8 and Canser, there are additional blinking codes which, however, do
not indicate device errors but rather a status or an external error.
5.5.1.5 UNI8 - TEDS
With the UNI8 module, particular blinking codes for status indication are already set as default settings.
These can be arbitrarily changed and adapted to the user’s own requirements. The default settings for
the blinking codes for the respective modules are:
Module-status
Color
Blinking code
Other or no sensors
1
RED
LED blinks rapidly
For “Not adjusted”
GREEN
LED blinks rapidly
For “Stored adjustment values”
GREEN
LED blinks normally
For “Successfully adjusted”
GREEN
LED blinks normally
For “Adjustment running...”
YELLOW
LED shines (no blinking)
For “Shunt calibration running...”
YELLOW
LED shines (no blinking)
1
TEDS-sensors: blinks only red after a TEDS-sensor was connected any time before