30 Startup
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
2.2.3 IXXAT interface cards
USB-to-CAN II
The current IXXAT-driver handling is to be used for imc CANSAS as follows:
1. First install the most up-to-date driver package VCI V3.
2. NEXT (!) install the present package VCI V2.20.
Remarks:
Version VCI 2.20 from IXXAT is no longer a real driver package! In contrast to all previous VCI2
predecessor versions, the VCI 2.20 no longer contains any real driver files, but is an add-on to drivers
of version VCI 3. The version VCI 2.20 thus no longer works in "stand alone" capacity. It is only a
"Wrapper-package" for the purpose of providing programs such as imc CANSAS with the benefit of the
newest VCI 3 driver.
This means that all IXXAT-interfaces can also be used for imc CANSAS under 64-bit Windows 7, if
IXXAT makes the corresponding drivers available!
IXXAT recommends the use of this new VCI-driver-combination for all Windows versions (as of
Windows 2000).
Further information can be found at the IXXAT web site http://www.ixxat.de in the Internet.
2.2.4 PEAK interface cards
Please note the instructions in the PEAK documentation.
Drivers for PEAK interfaces can be found on the CANSAS CD in "Driver\Peak".
After the driver has been installed, the computer must be re-started.
To Next Page
Loading...
