Important information 21
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
1.4.1.6 Guarantee
Each device is subjected to a 24-hour "burn-in" before leaving imc. This procedure is capable of
recognizing almost all cases of early failure. This does not, however, guarantee that a component will not
fail after longer operation. Therefore, all imc devices are guaranteed to function properly for one year.
The condition for this guarantee is that no alterations or modifications have been made to the device by
the customer.
1.4.1.7 Before Starting
Condensation may form on the circuit boards when the device is moved from a cold environment to a
warm one. In these situations, always wait until the device warms up to room temperature and is
completely dry before turning it on.
We recommend that you allow an approx. 30 min. warm-up phase before starting a measurement.
The module has been designed for use in clean and dry environments. They are not to be operated in 1)
exceedingly dusty and/ or wet environments, 2) in environments where danger of explosion exists nor 3)
in environments containing aggressive chemical agents.
Always arrange your cables and signal leads in a safe fashion. Think prevention!
Never connect or disconnect signal leads during thunderstorms.
To Next Page
Loading...
