IMC CANSAS - Edit - Paste; Edit - New; Edit - Rename

86 Operation
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
3.4.2.4 Edit - Paste
Purpose: Inserts Clipboard contents into an input box or settings into a different module.
Shortcuts
Toolbar:
Keyboard: CTRL+V
Remarks: A copy of the Clipboard's contents is inserted at the cursor's location. If the Clipboard is
currently empty the command is not available. The command only works on the controls of the
Properties dialogs and when editing names in the Module Tree.
If module settings are the contents of the Clipboard, they can be applied in the selected module. The
command is only enabled if the module type whose settings are in the Clipboard matches the selected
module type.
3.4.2.5 Edit - New
Purpose: Adds a new CAN-message or a virtual channel to a imc CANSAS module.
Shortcuts
Toolbar:
Prerequisite: A single imc CANSAS module must be currently selected in the Module Tree. If multiple
modules are selected, this command is not accessible.
The current selection can also be any of the various entries subordinate to a imc CANSAS module; the
command will always apply to the corresponding module.
The command works in both Module Tree grouping modes.
Procedure: When the command is implemented, the entry for a new CAN-Bus message is placed under
the CAN-Bus Interface node. The message is automatically assigned a name.
If the Module Tree is in the mode Grouped by channels, a new entry is placed under the Virtual Channels
node. If the Module Tree is in the mode Grouped by message, the new entry is placed under the Without
CAN-Bus message node.
A name is assigned automatically. Then the program goes into editing-mode; the name can be changed.
The changed name is applied once the <Return> key is pressed.
Other properties of the new virtual channel can be set in its Properties dialog.
3.4.2.6 Edit - Rename
Purpose: The name of a imc CANSAS module, a CAN-message of a channel in the Module Tree can be
edited.
Shortcuts
Keyboard: F2
Remarks: The last entry selected can be edited.