Notes / Quality Management / Customer Support 17
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
1.3.5 Product Improvement / Change Requests
You can help us to improve our documentation by giving us feedback on the following questions:
What terms or descriptions are incomprehensible?
What additions and enhancements you suggest?
Where have material mistakes slipped in?
Which spelling or typing errors have you found?
Responses and other feedback should be directed to the Hotline (phone / e-mail)
or by writing to:
imc Meßsysteme GmbH
Voltastrasse 5
D - 13355 Berlin
Germany
1.3.6 Other Notes
imc imc CANSAS satisfies the EMC requirements for unrestricted use in industrial settings.
Any additional devices connected to imc CANSAS must satisfy the EMC requirements as specified by
the responsible authority (within Europe
1
) in Germany the BNetzA - "Bundesnetzagentur" (formerly
BMPT-Vfg. No. 1046/84 or No. 243/91) or EC Guidelines 2004/108/EEC. All products which satisfy
these requirements must be appropriately marked by the manufacturer or display the CE
certification marking.
Products not satisfying these requirements may only be used with special approval of the regulating
body in the country where operated.
All signal lines connected to imc CANSAS must be shielded and the shielding must be grounded.
The EMC tests were carried out using shielded and grounded input and output cables with the
exception of the power cord. Observe this condition when designing your experiment to ensure
high interference immunity and low jamming.
See also General Notes \ Precautions for operation \ Grounding, shielding \ Shielding
1
If you are located outside Europe, please refer the appropriate EMC standards used in the country of operation.
16
To Next Page
Loading...
