Menu functions 99
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
If the box "Configure after 'Finish' " is checked, then this configuration is automatically updated in the
module after exiting the dialog.
The scaling values can be checked on the Scaling tab afterwards.
Limitations:
This function is not available for:
o Strain-gauge measurement
o Temperature measurement
The scaling distance between X1 and X2 must be at least 1/200 of the input range end value
To Next Page
Loading...
