Mitsubishi FR-A800

Parameter List
Parameter list (by parameter number)
140
PARAMETERS
Control system
functions
877 G220
Speed feed forward control/model
adaptive speed control selection
0 to 2 1 0
200,
251
878 G221
Speed feed forward filter 0 to 1 s 0.01 s 0 s 200
879 G222
Speed feed forward torque limit 0 to 400% 0.1% 150% 200
880 C114
Load inertia ratio 0 to 200 times 0.1 7
192,
200,
251
881 G223
Speed feed forward gain 0 to 1000% 1% 0% 200
Regeneration avoidance
function
882 G120
Regeneration avoidance operation
selection
0 to 2 1 0 621
883 G121
Regeneration avoidance operation
level
300 to 800 V 0.1V
DC380 V

621
DC760 V

884 G122
Regeneration avoidance at
deceleration detection sensitivity
0 to 5 1 0 621
885 G123
Regeneration avoidance
compensation frequency limit value
0 to 590 Hz, 9999 0.01 Hz 6 Hz 621
886 G124
Regeneration avoidance voltage
gain
0 to 200% 0.1% 100% 621
Free
parameters
888 E420
Free parameter 1 0 to 9999 1 9999 271
889 E421
Free parameter 2 0 to 9999 1 9999 271
Energy saving monitor
891 M023
Cumulative power monitor digit
shifted times
0 to 4, 9999 1 9999
359,
379
892 M200
Load factor 30 to 150% 0.1% 100% 379
893 M201
Energy saving monitor reference
(motor capacity)
0.1 to 55 kW
 0.01 kW 
Rated inverter
capacity
379
0 to 3600 kW
 0.1 kW 
894 M202
Control selection during
commercial power-supply
operation
0 to 3 1 0 379
895 M203
Power saving rate reference value 0, 1, 9999 1 9999 379
896 M204
Power unit cost 0 to 500, 9999 0.01 9999 379
897 M205
Power saving monitor average time 0 to 1000 h, 9999 1 h 9999 379
898 M206
Power saving cumulative monitor
clear
0, 1, 10, 9999 1 9999 379
899 M207
Operation time rate (estimated
value)
0 to 100%, 9999 0.1% 9999 379
Function
Pr.
Pr.
group
Name Setting range
Minimum
setting
increments
Initial value
Refer
to
page
Customer
setting
FM CA