USB on-the-go full-speed (OTG_FS) RM0402
1082/1163 RM0402 Rev 6
OTG_HCCHAR1 to control. During the setup stage, the application is expected to set
the PID field in OTG_HCTSIZ1 to SETUP.
• Interrupt OUT transactions
A typical interrupt OUT operation is shown in Figure 347. The assumptions are:
– The application is attempting to send one packet in every frame (up to 1 maximum
packet size), starting with the odd frame (transfer size = 1 024 bytes)
– The periodic transmit FIFO can hold one packet (1 KB)
– Periodic request queue depth = 4
The sequence of operations is as follows:
1. Initialize and enable channel 1. The application must set the ODDFRM bit in
OTG_HCCHAR1.
2. Write the first packet for channel 1.
3. Along with the last word write of each packet, the OTG_FS host writes an entry to the
periodic request queue.
4. The OTG_FS host attempts to send an OUT token in the next (odd) frame.
5. The OTG_FS host generates an XFRC interrupt as soon as the last packet is
transmitted successfully.
6. In response to the XFRC interrupt, reinitialize the channel for the next transfer.
To Next Page
Loading...
Need help?
General
