6/02
4-54
DC1632/2240
REP 7.2
Prelaunch Training/Review
Repairs and Adjustments
REP 7.2 Tray 5 Feed Roll
Parts List on PL 2.14
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Rear Cover (REP 14.2).
2. Remove Power Switch Cover (REP 14.6).
3. Remove Upper Rear Left Cover (REP 14.4).
4. Close Left Door Transport.
5. Remove Tray 5 (REP 7.1).
6. Remove Chute (Figure 1).
a. Remove Screws (3).
b. Lift to remove Chute.
Figure 1 Removing Chute
7. Remove Feed Roll (Figure 2).
a. Release Locking Tab from groove on shaft and slide Lock Roll away from Feed Roll.
b. Slide Feed Roll to disengage drive pin and remove Feed Roll.
Figure 2 Removing Feed Roll
Replacement
Ensure Arrow is positioned as shown (Figure 3).
Figure 3 Installing Feed Roll
Screws (3)
Chute
Locking
Tab
Lock Roll
Feed
Roll
Arrow
To Next Page
Loading...
Need help?
General