6/02
6-8
DC1632/2240
dC122, dC129
Prelaunch Training/Review
General Procedures and Information
dC122 Shutdown History
Purpose
To display the Last 40 Faults (History).
NOTE:
1. fault detected while in Service Mode are not counted.
2. An Interlock open while the machine is stopped is not counted.
3. If multiple faults occurred in the machine, the primary fault is recorded.
Procedure
1. Enter the Diagnostic Mode. Refer to Entering Diagnostic Mode using the PWS.
2. Select the Diagnostics Tab.
3. Select the Shutdown Hist (dC122) tab.
4. The system displays the faults that occurred in Customer Mode since the last service call
closeout, up to a maximum of 40 faults.
5. The information in the lower right corner of the screen (Input, Original, Paper, Tray, Out-
put) reflects the fault highlighted in the Table.
6. The following subsets of data are available:
ï Last 40 Faults History (default screen).
- displays the 40 newest faults and lists copy count when each occurred.
ï Last 40 Faults Occurrences
- displays the 40 newest faults and lists the number of occurrences.
ï DADF Jams
- displays the 40 newest DADF jams and lists copy count when each occurred.
ï Paper Jams
- displays the 40 newest paper jams and lists copy count when each occurred.
ï Fail
- displays the 40 newest non-jam faults and lists copy count when each occurred.
7. To clear the shutdown history, select Complete Closeout in the Service Mode Exit
screen (dC188). Exiting from the Service Mode clears all data in the Shut-Down History.
dC129 System Registration Setup
Purpose
Performs the Lead Registration and Side Registration adjustments by looking at the output of
the built-in Test Pattern.
NOTE: For details on the dC129 System Registration adjustment, see ADJ 9.9 IOT Registra-
tion Series (dC129).
To Next Page
Loading...
Need help?
General