6/02
6-78
DC1632/2240
dC355, dC371
Prelaunch Training/Review
General Procedures and Information
dC355 Hard Disk Diagnostic Program
Purpose
NOTE: For details on dC355 Hard Disk Diagnostic Program, see Adjustments: ADJ 9.8.
dC371 Configuration Page
Purpose
Allows easy viewing and set-up of machine configuration.
Procedure
1. Enter the Diagnostic Mode. Refer to Entering Diagnostic Mode using the PWS.
2. Select Adjustments on the Service Entry Screen.
3. Select NVM Init, S/R (the default screen).
4. Select Configuration Page (dC371). The Configuration Page Screen is displayed.
5. Make selections on the screen from the following categories:
a. Market Place
ïXC (NASG)
ï XE (ESG)
ïFX
ï FX / AP
b. Machine Config
ï Digital Copier
ï Copier / Printer
ï Copier / Printer / Scanner
ï Printer with UI
c. Output Device(s)
ï Simple Catch Tray
ï Ofssetting Catch Tray
ï Finisher
d. Input Device
ïDADF
ï Platen Only
6. Select Save to save the options or select Reset to reset the default settings back to origi-
nal options prior to entering Configuration Page (dC371).
To Next Page
Loading...
Need help?
General