Anritsu MS2026C - Marker on Trace

:CALCulate:MARKer Subsystem VNA Commands
3-60 PN: 10580-00306 Rev. E MS20xxC PM
Marker On Trace
:CALCulate:MARKer<Mk>:SOURce
Description: Sets the specified marker <Mk> to the given trace <Tr>. <Mk> is the
marker number in the range of 1 to 8. If no marker number is specified,
then the marker number (the <Mk> value) defaults to 1. <Tr> is the
trace and must be one of the following 9 values:
TR1|TR2|TR3|TR4|MEM1|MEM2|MEM3|MEM4|ALL
The query version of the command returns “TR1” if the specified marker
is on trace 1, “TR2” if on trace 2, “TR3” if on trace 3, “TR4” if on trace 4,
“MEM1” if on trace 1 memory, “MEM2” if on trace 2 memory, “MEM3” if
on trace 3 memory, “MEM4” if on trace 4 memory, and “ALL” if the
specified marker is on all 4 traces. Note that the set version of this
command sets the specified marker as the active marker.
If an error occurs, such as “Marker not ON”, then the query version of
the command returns an error code of –400.
Syntax: :CALCulate:MARKer<Mk>:SOURce <Tr>
:CALCulate:MARKer<Mk>:SOURce?
Cmd Parameter: <char> <Tr>
Query Response: <char> <Tr>
Front Panel
Access: Marker, Marker on Trace