Anritsu MS2026C - Internal Bias Tee Current; External Bias Tee Current

:INPut Subsystem VNA Commands
3-92 PN: 10580-00306 Rev. E MS20xxC PM
Internal Bias Tee Current
:INPut<port_no>:BIAS:CURRent
Description: Sets the internal bias tee current limit for the specified port. When this
limit is exceeded, the Bias Tee trips (turns OFF). <port_no> is the
specified internal bias tee port number, 1 to 2. The query version of this
command returns either the measured internal current or the set
internal current limit (both are returned in milliampere units). To
return the measured internal current for the specified port number,
send the query command either with no value specified after the “?”
(default condition) or with a value of 0 specified after the “?”. Note that
the query result for the measured internal current is valid only if the
Bias Tee state is set to internal. If a value of 1 is specified after the “?”,
then the query version of this command returns the internal current
limit that is set for the given port number.
Syntax: :INPut<port_no>:BIAS:CURRent <current>
:INPut<port_no>:BIAS:CURRent? [0|1]
Cmd Parameter: <NRf> <current> (milliampere)
Query Response : <NR3> <milliampere> (returns value in milliampere)
Range: 0mAto450mA
Default Value: 450 mA when querying the internal current limit
(:INPut<port_no>:BIAS:CURRent? 1). The default value for
querying the measured current depends upon what is connected to the
port.
Default Unit: milliampere (mA)
Front Panel
Access: Shift-3 (Sweep), Configure Ports, Bias Tee Setup, Int Current Limit P1/P2
External Bias Tee Current
:INPut<port_no>:BIAS:EXTernal:CURRent?
Description: Returns the external bias tee current. <port_no> is the specified
external bias tee port number, 1 to 2.
Syntax: :INPut<port_no>:BIAS:EXTernal:CURRent?
Cmd Parameter: NA (query only)
Query Response : <NR3> (milliampere)
Default Unit: mA
Front Panel
Access: NA