Anritsu MS2026C - VVM Commands

VVM Commands Vector Voltmeter Commands
4-2 PN: 10580-00306 Rev. E MS20xxC PM
4-2 VVM Commands
Table 4-1. VVM Commands Subsystems
Keyword Parameter Data or Units
:MMEMory Refer to “:MMEMory:STORe Subsystem” on page 4-6
:TRACe Refer to “:TRACe VVM Subsystem” on page 4-8
[:SENSe]
:VVM Refer to “[:SENSe]:VVM Subsystem” on page 4-11
:CABLe Refer to “[:SENSe:]:VVM:CABLe Subsystem” on page 4-14
:FREQuency Refer to “[:SENSe]:VVM:FREQuency Subsystem”
on page 4-15
:REFerence Refer to “[:SENSe:]:VVM:REFerence Subsystem”
on page 4-16
:FETCh
:VVM Refer to “:FETCh:VVM Subsystem” on page 4-17
:REFerence Refer to “FETCh:VVM:REFerence Subsystem” on page 4-20
The following commands are described in Chapter 3.
[:SENSe]:CALibration Refer to “[:SENSe]:CALibration Subsystem” on page 3-104
[:SENSe]:CORRection Refer to “[:SENSe]:CORRection Subsystem” on page 3-105
[:SENSe]:CORRection
:CKIT
Refer to “[:SENSe]:CORRection:CKIT Subsystem”
on page 3-108
[:SENSe]:CORRection
:CKIT:USER
Refer to “[:SENSe]:CORRection:CKIT:USER Subsystem”
on page 3-114
[:SENSe]:CORRection
:COLLect
Refer to “[:SENSe]:CORRection:COLLect Subsystem”
on page 3-118