Anritsu MS2026C - Calibration Type

[:SENSe]:CORRection:COLLect Subsystem VNA Commands
3-130 PN: 10580-00306 Rev. E MS20xxC PM
Calibration Type
[:SENSe]:CORRection:COLLect:TYPE
Description: Compare with “[:SENSe]:CORRection:COLLect:CTYPe” on page 3-129,
which has more functions than this command. This command is being
kept for backwards compatibility. It configures the calibrate type.
<cal type> is the calibration type and must be one of the following
values:
RF2P|RFP1|RFP2|RFBP|TRFP|TRRP|TRBP|RRP1|RRP2|RRBP|2PFP|
2PRP
Syntax: [:SENSe]:CORRection:COLLect:TYPE <cal type>
[:SENSe]:CORRection:COLLect:TYPE?
Cmd Parameter: <char> <cal type>
Query Response: <char> <cal type>
Default Value: RF2P
Front Panel
Access: Shift-2 (Calibrate), Cal Type
CAL TYPE DESCRIPTION
RF2P Full 2 Port
RFP1 Full Port 1
RFP2 Full Port 2
RFBP Full Both Ports
TRFP Trans Response Fwd Path
TRRP Trans Response Rev Path
TRBP Trans Response Both Paths
RRP1 Reflection Response Port 1
RRP2 Reflection Response Port 2
RRBP Reflection Response Both Ports
2PFP 1 Path 2 Port Fwd Path
2PRP 1 Path 2 Port Rev Path