Power Monitor Commands :CALCulate:PMONitor:RELative Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 5-7
5-6 :CALCulate:PMONitor:RELative Subsystem
This subsystem contains commands to turn the relative power level on and off.
Relative State
:CALCulate:PMONitor:RELative[:STATe]
Description: Enables/disables the Relative power level. Setting the value to ON or 1
turns on the relative power level. Setting the value to OFF or 0 turns off
the relative power level. The query version of the command returns a 1
if the relative power level is ON and returns a 0 if the relative power
level is OFF.
Syntax: :CALCulate:PMONitor:RELative[:STATe] OFF|ON|0|1
:CALCulate:PMONitor:RELative[:STATe]?
Cmd Parameter: <boolean> OFF|ON|0|1
Query Response: <bNR1> 0|1
Default Value: 0
Example: To turn Off the relative power:
:CALCulate:PMONitor:RELative:STATe OFF
:CALCulate:PMONitor:RELative 0
To turn On the relative power:
:CALCulate:PMONitor:RELative:STATe ON
:CALCulate:PMONitor:RELative 1
Front Panel
Access: Measure or Shift-4 (Measure), Relative Power
To Next Page
Loading...
