Anritsu MS2026C - 3-35:System Subsystem; Motherboard Temperature; 3-36 Trace Subsystem; Trace Data Transfer

VNA Commands :SYSTem Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-153
3-35 :SYSTem Subsystem
The commands in this subsystem relate to the current operating state of the instrument.
Motherboard Temperature
:SYSTem:MBTemperature?
Description: This command returns the current mother board temperature in
degrees Celsius.
Syntax: :SYSTem:MBTemperature?
Cmd Parameter: NA (query only)
Query Response: <NR3> (degree Celsius)
Front Panel
Access: NA
3-36 Trace Subsystem
This subsystem contains commands related to the transfer of trace data to and from the
instrument.
Trace Data Transfer
:TRACe[:DATA]?
Description: Transfers the trace data of the given trace from the instrument to the
controller.
The format of the block data that is returned can be specified by the
command :FORMat:DATA. The response begins with an ASCII header
that specifies the number of data bytes. It appears in the format #AX,
where A is the number of digits in X, and X is the number of bytes
that follow the header. Each data point is separated by a comma
delimiter. Independent of the Graph Type that is associated with the
trace, each data point that is transferred by this command consists of
complex measurement data (Real and Imaginary values for that point).
A 551 point trace therefore has a total of 1102 points that get
transferred.
Syntax: :TRACe[:DATA]? [1]|2|3|4
Cmd Parameter: NA (query only)
Query Response: <block>
Related Command: :FORMat:DATA;
:CALCulate<Tr>:DATA?
Front Panel
Access: NA