Anritsu MS2026C - DUT Port Setup

[:SENSe]:CORRection:COLLect Subsystem VNA Commands
3-124 PN: 10580-00306 Rev. E MS20xxC PM
DUT Port Setup
[:SENSe]:CORRection:COLLect:CONNector<port_no>
Description: Sets the connector family for the given port number. <port_no> is the
port number, 1 or 2. <connector> defines the connector family and
can be given in either long or short form. [connector-name] is a
string that defines the name that is associated with the given
<connector> and is optional. [connector-name] must be enclosed
by parentheses.
Note that the connector must be valid for the current calibration line
type.