MS20xxC PM PN: 10580-00306 Rev. E 1-1
Chapter 1 — General Information
1-1 About this Manual
This SCPI Programming Manual provides information for remote operation of the MS20xxC
Vector Network Analyzer (MS2026C, MS2027C, MS2028C, MS2036C, MS2037C, and
MS2038C) using commands sent from an external controller via Ethernet or USB connection.
This Programming Manual includes the following:
• An overview of Ethernet and USB connection to the MS20xxC
• An overview of Standard Commands for Programmable Instruments (SCPI) command
structure and conventions
• The IEEE common commands that are supported by the MS20xxC
• A complete listing and description of all the SCPI commands that can be used to
remotely control functions of the MS20xxC. These commands are organized by
instrument mode and are listed in Chapter 8, “All Mode Commands”.
This manual is intended to be used in conjunction with the VNA Master MS20xxC Vector
Network Analyzer User Guide, Anritsu Part Number 10580-00306. Refer to that manual for
general information about the MS20xxC, including equipment setup and operating
instructions.
1-2 Introduction
This chapter provides a general description of remote programming setup, Ethernet and USB
interface connections, and cable requirements.
1-3 Remote Programming Setup and Interface
Remote programming and operation of the MS20xxC is accessed via the Ethernet or USB
interface. The following paragraphs provide information about the interface connections,
cable requirements, and setup for remote operation.
Ethernet Interface Connection and Setup
The MS20xxC fully supports the IEEE-802.3 standard. Most MS20xxC functions (except
power On/Off) can be controlled via an Ethernet connection to a PC that is connected directly
(with an Ethernet cross-over cable) or through a network. The MS20xxC software supports
the TCP/IP network protocol.
To Next Page
Loading...
